Supercharger nose seal
10-06-2003, 09:05 AM
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Jul 2003
Location: Markham, Ontario, Canada
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
Supercharger nose seal
Does anyone know how to replace the nose seal on the pulley? My car being a 93, I am assuming that I can pull off the pulley and replace the nose seal without removing the charger from the car. It is leaking oil.
Part number for the seal that is needed would very much help.
Thanks in advance.
Part number for the seal that is needed would very much help.
Thanks in advance.
10-07-2003, 04:55 PM
#2
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Jul 2003
Location: Markham, Ontario, Canada
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
Any thoughts, guys? It'* not an urgent situation, but I would rather fix it before it becomes a problem (plus my driveway is starting to look really bad 
)
Thanks.
)Thanks.
10-07-2003, 07:32 PM
#3
Junior Member
Posts like a Ricer Type-R
http://www.bonnevilleclub.com/forum/...t=bearing+seal
You will need a puller to remove the pulley,I used a 3 jaw puller just use slow even pressure an it should slide off.the seal,behind the pulley is held in by a wire retainer,remove it.remove the seal using a small screwdriver or pick with a bent tip.The shaft will then have to be pressed out of the bearings.Take it to a automotive machine shop to have this done,and have them put the new bearings in.I did this 2 weeks ago and my concern ti with the new seal being a Viton 2 lip seal instead of the 2 lip teflon seal from Eaton (OEM).But so far I have had no leakage.These are the part numbers for the m-62 Bearing: 1 - 6204.C3 Bearing; 1 - 6203.C3
Seal, 1 - 7965 CR.Be sure and apply some grease to the lips of the new seal.
Is your */c knocking at idle? You might need a ZZ coupler also.
Seal, 1 - 7965 CR.Be sure and apply some grease to the lips of the new seal.
Is your */c knocking at idle? You might need a ZZ coupler also.
10-30-2003, 02:05 PM
#5
Member
Posts like a V-Tak
Join Date: May 2003
Location: Knoxville, TN
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
11-05-2003, 11:46 PM
#7
Junior Member
Posts like a Ricer Type-R
The liquid gasket (red) is purchased from the dealer. They have the right stuff for cheap. It'* used on the nosedrive AND gear housing mating surfaces. To be more specific, it'* used between the nosedrive and gear housing, and between the gear housing and rotor housing.
See my post with all the pics for more details. You'll see the tube in my 'shopping list'.
See my post with all the pics for more details. You'll see the tube in my 'shopping list'.
Thread
Thread Starter
Forum
Replies
Last Post
Brian95Blown
Forced Induction
1
11-10-2004 06:01 PM