More questions.
#1
Senior Member
Certified Car Nut
Thread Starter
More questions.
With that Button pod i'm working with (the perform shift TC pod) i've got a new idea. My best pod is a 3 button one. So i'm figuring i'll just rewire the angel eye halos to a switch, and the driving lamps to the pod, with a starter on the TC momentary button. Can you guys give me a diagram based off of this. I know the Ride buttons share the bottom 4 pin connector.
#2
Junior Member
Posts like a Ricer Type-R
This is gonna take some work. I know the TC uses the brn/wht wire, but you don't have that part of the harness. I also think it shares a ground with the other buttons. I'll have to do some more digging in the factory manual. I'm marking pages as I go, as the entire pod isn't on one page, but spread out amongst the systems that use it.
#3
Junior Member
Posts like a Ricer Type-R
You owe me for this one. This took an hour of service manuals and ripping into my own console. I don't have the pinouts for the perf/touring rides, as that wasn't an option in 93, so it isn't covered in my manuals.
The schematic/pinout for the TC/Shift connector is here:
The schematic/pinout for the TC/Shift connector is here:
#5
Senior Member
Certified Car Nut
Thread Starter
Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you Thank you
Thread
Thread Starter
Forum
Replies
Last Post
Hailey
Performance, Brainstorming & Tuning
35
03-18-2004 11:39 AM