HELP A NEW GUY OUT PLEASE.
#1
Junior Member
Thread Starter
Join Date: Jan 2006
Location: SUNNY FLORIDA
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
HELP A NEW GUY OUT PLEASE.
hi im new here, one quick question, i bought the 1993 bonnevelle, one owner very nice car, not a dent on it, garage kept. all i have found wrong with it is.
keyless entry works when it wants to, it eather on or off, 2 remotes are not the problem .
and the horn and button on steering wheel are not working.
all fuses ok.
thanks kirk
keyless entry works when it wants to, it eather on or off, 2 remotes are not the problem .
and the horn and button on steering wheel are not working.
all fuses ok.
thanks kirk
#2
Senior Member
True Car Nut
Hi Kirk, Welcome to BC, where it'* ALWAYS sunny!!
Anyway, I don't have your answers, though we have a number of guys who will probably be able to help you. To help them help you, what is your trim level SE, SSE, or SSEi? NA or Supercharged?
Anyway, I don't have your answers, though we have a number of guys who will probably be able to help you. To help them help you, what is your trim level SE, SSE, or SSEi? NA or Supercharged?
#3
DINOSAURUS BOOSTUS
Expert Gearhead
Kirk...
I would start by reprogramming both remotes with this procedure from the Techinfo section.
http://www.bonnevilleclub.com/techinfo/?article=59
On the horn button not working. Have you confirmed that the horns are indeed good or that power is not reaching the connectors on them?
If no, please use a multimeter set to DC volts while someone presses the horn, ground the black meter lead and touch the horn contact with the red lead. 12V should be read. This test would indicate that the horn is bad.
If power is present. The airbag/horn was probably put back on incorrectly at one time. This requires disconnecting power from the and following the airbag safetly procedures. Then pulling it an looking for something obstructing the pressing of the horn.
I would start by reprogramming both remotes with this procedure from the Techinfo section.
http://www.bonnevilleclub.com/techinfo/?article=59
On the horn button not working. Have you confirmed that the horns are indeed good or that power is not reaching the connectors on them?
If no, please use a multimeter set to DC volts while someone presses the horn, ground the black meter lead and touch the horn contact with the red lead. 12V should be read. This test would indicate that the horn is bad.
If power is present. The airbag/horn was probably put back on incorrectly at one time. This requires disconnecting power from the and following the airbag safetly procedures. Then pulling it an looking for something obstructing the pressing of the horn.
Thread
Thread Starter
Forum
Replies
Last Post
DADillac
Audio (and aftermarket electronics)
8
09-25-2008 05:28 PM
rmflyfish
Performance, Brainstorming & Tuning
9
10-25-2002 06:02 PM