Instrument Cluster 1992 SSE problem
#1
Instrument Cluster 1992 SSE problem
I have 1992 SSE with the typical dead instrument cluster.The tach and speedo work,and all else is dead.I have a spare cluster that died the same way,and would like to repair it and put it in the car.I see the tech info to guide me through this project is still not up and running.Could anyone give me some tips to guide me through the procedure,or anything specific to look for during disassembly and cleaning?Thanks in advance
#4
I had read somewhere that the instrument cluster needs to be carefully disassembled and cleaned,and I would assume cleaning anything that may be corroded and repair any poor solder joints.It seemed there was a procedure to do this,and took about 2 hours to do.It'* that disassembly procedure I was trying to locate.I'm just looking for some pointers from someone that has had one apart before.I apologize for being misleading.Thanks again.
#5
DINOSAURUS BOOSTUS
Expert Gearhead
Ohhhh is that all. Heck piece of cake.
Pull your dash trim panel and the panel under the column. Lower the column by the main bolts an inch or two. Remove the cluster.
Once the cluster is out, remove the golden screws on the back and leave the black screws in place. Carefully wiggle the boards apart and watch the areas where they are hooked together by wires.
I have a pic of it apart somewhere..lemme look.
Pull your dash trim panel and the panel under the column. Lower the column by the main bolts an inch or two. Remove the cluster.
Once the cluster is out, remove the golden screws on the back and leave the black screws in place. Carefully wiggle the boards apart and watch the areas where they are hooked together by wires.
I have a pic of it apart somewhere..lemme look.
#7
UPDATE:
I carefully disassembled the spare cluster I had,and cleaned any suspicious connections and touched up solder joints.Upon installation,I went ahead and clean the ground busses on the floor.The display still comes and goes.I guess it'* time to send it in and get it repaired.If I knew what I was looking for specifically on those PCB,it wouldn't be a bad fix.Overall,the cluster looked really good inside
I carefully disassembled the spare cluster I had,and cleaned any suspicious connections and touched up solder joints.Upon installation,I went ahead and clean the ground busses on the floor.The display still comes and goes.I guess it'* time to send it in and get it repaired.If I knew what I was looking for specifically on those PCB,it wouldn't be a bad fix.Overall,the cluster looked really good inside
#8
Member
Posts like a V-Tak
Join Date: Sep 2008
Location: PA
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
I have 1992 SSE with the typical dead instrument cluster.The tach and speedo work,and all else is dead.I have a spare cluster that died the same way,and would like to repair it and put it in the car.I see the tech info to guide me through this project is still not up and running.Could anyone give me some tips to guide me through the procedure,or anything specific to look for during disassembly and cleaning?Thanks in advance
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
JUNIOR74
Everything Electrical & Electronic
1
04-20-2008 08:59 PM
BonnevilleSSEGuy
General GM Chat
1
01-01-2004 02:35 PM