Electric problems
#21
Senior Member
True Car Nut
Join Date: May 2005
Location: _Phoenix, AZ_ _WCBF '05, '06, '07 Survivor_ ____NEBF '07 Remnant___
Posts: 3,448
Likes: 0
Received 6 Likes
on
6 Posts
Originally Posted by 1993 SLE
Originally Posted by BillBoost37
Better yet Bob.. did 93 have a BCM?
If no BCM, then I assume there is a wire connected to the headlight switch that runs somewhere similar, that may cause a similar issue....that'* why I said my info came from teh '97 FSM :P
#22
Senior Member
True Car Nut
Originally Posted by rdncktek
Ok I had to order the headlight switch over the internet at rock auto. I put it in on Saturday. I still have the same problems. no dash lights, no tail lights, no fog lights and it chimes when I open the door like I left the lights on. This started happening right after I got an alignment. Still open for any guesses.
Thanks,
Ron
Thanks,
Ron
I haven't read "check the fuses" yet either so I'd look at that too. If all of the fuses look good then I'd start looking at the Adaptive Lamp Module (ALM). I no longer have my 93 manuals and my 95 and 97 manuals are at Boosty'* so I don't have any reference materials nearby.
#23
Member
Posts like a V-Tak
Thread Starter
Join Date: Jan 2006
Location: Livermore,CA
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
I want to thank everyone for there replies. The fuses were my first point of attack. I will
look into the Adaptive Lamp Module. Again thanks for the help. Getting home when its dark makes it hard to work on during the week.
look into the Adaptive Lamp Module. Again thanks for the help. Getting home when its dark makes it hard to work on during the week.
#24
Member
Posts like a V-Tak
Thread Starter
Join Date: Jan 2006
Location: Livermore,CA
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
There is light at the end of the tunnel…I think… I have a fuse in slot 14 that keeps burning out. When I replace it before I start the car all my problems are gone. I start the car it blows the fuse. During my testing I ran out of 15 amp fuses so I put in a 25 amp and everything stayed on even after I started the car. I do not want to run the risk of a wiring melt down. If anyone could help me isolate how fuse 14 and the head light switch interact or what could be causing my over load I would appreciate it.
Thanks,
Ron
Thanks,
Ron
#25
Senior Member
True Car Nut
This is a psudo-bump for your thread. I no longer have a 93 service manual and my 95 which is similar is at BillBoost'* house. I will be going there later on today but wanted to bring this forward to see if someone else can take a peek at their manual.
#26
Junior Member
Join Date: Aug 2005
Location: North of Buffalo, NY *** NEBF '05, '06, '07 *** ***ONBF & NYBF 06; 07*** ***WCBF 06***
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by randman1
This is a psudo-bump for your thread. I no longer have a 93 service manual and my 95 which is similar is at BillBoost'* house. I will be going there later on today but wanted to bring this forward to see if someone else can take a peek at their manual.
Thread
Thread Starter
Forum
Replies
Last Post