replacing cup holder.
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Dec 2006
Posts: 386
Likes: 0
Received 0 Likes
on
0 Posts
replacing cup holder.
In order to replace the cup holder does the entire console have to come out.
i found this for the console :
http://www.bonnevilleclub.com/forum/...light=arm+rest
but was wondering if the internal armrest come out by itself to replace the cup holder.
i found this for the console :
http://www.bonnevilleclub.com/forum/...light=arm+rest
but was wondering if the internal armrest come out by itself to replace the cup holder.
#2
Senior Member
True Car Nut
Join Date: May 2005
Location: _Phoenix, AZ_ _WCBF '05, '06, '07 Survivor_ ____NEBF '07 Remnant___
Posts: 3,448
Likes: 0
Received 6 Likes
on
6 Posts
I am pretty sure it does as I am sure I removed the whole armrest, bin, cupholder at a junkyard without lifting the entire console. IIRC, you do need to "pop" out the triangle trim piece between the gear selector and the front of the bin to gain access to the front nuts of the bin. Then, like the link you provided says, you remove the back cover, inside the bin, to gain access to the back nuts.
#4
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Dec 2006
Posts: 386
Likes: 0
Received 0 Likes
on
0 Posts
yup same thing here haro
ok ,, the part number is 25639346 from gm parts direct.
it is a cup holder only.
on closer examination the cup holder will just snap on .
the original cup holder has closed ends .. that attach to the hinge.
the replacement has J shaped ends ..
I removed the remaining plastic that was left over from the original.
just pinched it with some pliers and pulled it off.
then snapped the new cupholder in place.. i didnt have to remove any part of the console.
ok ,, the part number is 25639346 from gm parts direct.
it is a cup holder only.
on closer examination the cup holder will just snap on .
the original cup holder has closed ends .. that attach to the hinge.
the replacement has J shaped ends ..
I removed the remaining plastic that was left over from the original.
just pinched it with some pliers and pulled it off.
then snapped the new cupholder in place.. i didnt have to remove any part of the console.
Thread
Thread Starter
Forum
Replies
Last Post
ssesc93
General GM Chat
6
01-27-2005 11:15 PM
baggsend
1992-1999
4
12-24-2003 11:22 AM