Unlearn a remote
09-06-2015, 09:26 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2015
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Unlearn a remote
This is probably a stupid question, but is there any way for a vehicle to unlearn the factory remote? My wife'* remote died and I paired my extra one to her car and now it controls both my truck and her car at the same time.
Is there anything I can do? Any way to wipe the remote from my truck?
I drive a 2007 Avalanche.
Thanks in advance!
Is there anything I can do? Any way to wipe the remote from my truck?
I drive a 2007 Avalanche.
Thanks in advance!
09-06-2015, 10:30 PM
#2
Senior Member
True Car Nut
You'll need to reprogram the truck with only the remotes you wish to use. When that happens, it should no longer work with the remote that your wife is now using.
09-06-2015, 10:34 PM
#3
Senior Member
True Car Nut
Seems pretty straightforward thankfully:
Chevy Avalanche free remote keyless entry fob programming instructions 2007, 2008, 2009 and 2010 (with remote start and without remote start) | Carandtruckremotes.com Blog ? free keyless remote programming instructions
Chevy Avalanche free remote keyless entry fob programming instructions 2007, 2008, 2009 and 2010 (with remote start and without remote start) | Carandtruckremotes.com Blog ? free keyless remote programming instructions
Switch ignition ON.
Repeatedly press vehicle information button Fig. 2 [A] until PRESS TO RELEARN REMOTE KEY is displayed.
Press set/reset button Fig. 2 [B] until REMOTE KEY LEARNING ACTIVE is displayed.
Programming mode activated, proceed as follows:
Press and hold LOCK and UNLOCK buttons on first remote transmitter simultaneously for 15 seconds.
Wait for acoustic signal (indicates correct programming).
Repeat above procedure to program remaining remote transmitters.
Switch ignition OFF to exit programming mode.
Remote transmitters can also be programmed using diagnostic equipment.
NOTE: A maximum of 8 remote transmitters can be programmed.
Repeatedly press vehicle information button Fig. 2 [A] until PRESS TO RELEARN REMOTE KEY is displayed.
Press set/reset button Fig. 2 [B] until REMOTE KEY LEARNING ACTIVE is displayed.
Programming mode activated, proceed as follows:
Press and hold LOCK and UNLOCK buttons on first remote transmitter simultaneously for 15 seconds.
Wait for acoustic signal (indicates correct programming).
Repeat above procedure to program remaining remote transmitters.
Switch ignition OFF to exit programming mode.
Remote transmitters can also be programmed using diagnostic equipment.
NOTE: A maximum of 8 remote transmitters can be programmed.
09-06-2015, 11:30 PM
#5
Senior Member
True Car Nut
Not quite. Usually if you just reprogram using the remote you want to use, it should stop working with the one that was moved to the other car.
Thread
Thread Starter
Forum
Replies
Last Post
