2011 Lacrosse rear speaker
#1
2011 Lacrosse rear speaker
Hello all,
I have a 2011 Buick Lacrosse CXS that I need to replace right rear deck speaker. I folded down the back seat leaving two pillars of the seat on each side that finish out the seat. I found 3 push pins that hold the deck cover down. At this point I get a little lost on what should happen. it doesnt just lift up and over the pillars on each side. So do they need to come out or do you just bend the cover in the middle a small amount? Also it has the privacy screen. How does that come apart or can I leave it together. Thanks in advance for any input.
Shawn
I have a 2011 Buick Lacrosse CXS that I need to replace right rear deck speaker. I folded down the back seat leaving two pillars of the seat on each side that finish out the seat. I found 3 push pins that hold the deck cover down. At this point I get a little lost on what should happen. it doesnt just lift up and over the pillars on each side. So do they need to come out or do you just bend the cover in the middle a small amount? Also it has the privacy screen. How does that come apart or can I leave it together. Thanks in advance for any input.
Shawn
#2
Senior Member
True Car Nut
If you can, post some pictures. I don't know of anyone here that'* been into the rear deck of one of these.
#4
Senior Member
True Car Nut
Me too, just haven't done one of these. Hopefully hittleconstruc will come back with some pics.
#5
Senior Member
1. rotate seat down
2. remove the left and rear upper quarter panels.....
3. remove the 3 front pins
4. Lift up rear panel assembly, slide seat belts out of panel, and disconnect electrical connector.....
* if you have DB3, sunshade option, there are 3 nuts that you access through the trunk area...
2. remove the left and rear upper quarter panels.....
3. remove the 3 front pins
4. Lift up rear panel assembly, slide seat belts out of panel, and disconnect electrical connector.....
* if you have DB3, sunshade option, there are 3 nuts that you access through the trunk area...
The following users liked this post:
CathedralCub (03-29-2019)
The following users liked this post:
CathedralCub (03-29-2019)
#7
Senior Member
True Car Nut
Cool, looking forward to it!
#8
1. rotate seat down
2. remove the left and rear upper quarter panels.....
3. remove the 3 front pins
4. Lift up rear panel assembly, slide seat belts out of panel, and disconnect electrical connector.....
* if you have DB3, sunshade option, there are 3 nuts that you access through the trunk area...
2. remove the left and rear upper quarter panels.....
3. remove the 3 front pins
4. Lift up rear panel assembly, slide seat belts out of panel, and disconnect electrical connector.....
* if you have DB3, sunshade option, there are 3 nuts that you access through the trunk area...
The following users liked this post:
Mad_Coachman (06-02-2021)
#10
Senior Member
True Car Nut
The last post in this thread (before May 30, 2021) is over two years old. Please do not post in threads that have no entries less than six months old. Please refer to https://www.gmforum.com/introduction...-first-304557/ for more details. If you have a question related to this thread'* subject, please start a new thread with a reference to this thread.
Thread closed.
Thread closed.
Thread
Thread Starter
Forum
Replies
Last Post
black_friday
Audio (and aftermarket electronics)
3
12-19-2006 12:53 PM