Thinking about building a box...
#11
Senior Member
Posts like a Turbo
Join Date: Jul 2010
Location: Sacramento, CA.
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
the subs will be firing back, toward my taillights. and the port will be a slot port on the same face as the subs, right above the subs actually.
I made the box a little large to compensate for sub volume, ect. I was going to add a couple small braces but not to concerned since subs r only 500w max and only receiving 150w RMS each. its not a high power system. Just want to get some air flowing, and a correct tune.
I made the box a little large to compensate for sub volume, ect. I was going to add a couple small braces but not to concerned since subs r only 500w max and only receiving 150w RMS each. its not a high power system. Just want to get some air flowing, and a correct tune.
#12
Senior Member
Posts like a Turbo
Join Date: May 2009
Location: Hibbing MN
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
to be honest with the few dif boxes i built and had in my Bonne i can say that box will not fit through the trunk opening at all mang. my box was 36x17x15.5 and i had to shave off part of the center top edge of the box for it to fit....and that was a single 15 box. i d suggest making a ported box for a pair of 12s if you end up doin a trade or something.
Thread
Thread Starter
Forum
Replies
Last Post
jachin
Audio (and aftermarket electronics)
12
04-06-2004 04:33 PM
parallelcircuits
General GM Chat
13
08-07-2003 12:10 AM