Fuse holder is melting??
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2011
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Fuse holder is melting??
ok so i have a 02 bonne SSEI and im wired up for subs with 0 gauge wire and i have the 150 ANL fuse under the back seat, when i pound the sounds for a little while i can smell something burning and i lift the back seat up and its the fuse holder melting only on the input from the battery side i figured it was to close to the metal in the seat cushion so i moved it and it still does it 3 fuse holders later and i really dont have an extreme setup just a jl 1000/1 and a 13.5 w7 ANY SOLUTIONS
#3
Senior Member
True Car Nut
I would think you have one of two problems. Your wiring could be undersized for the current it is carrying, or you could have loose connections in the fuse box.
Feel the wires to see if they are hot.
Feel the wires to see if they are hot.
#4
Member
Posts like a V-Tak
Join Date: Aug 2011
Location: Georgia
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
I would check the power wire for a short to ground, especially where it goes through the fire wall. Or you might have a loose ground connection. I would assume 0 gauge is more than sufficient, unless you are running some super high power amp.
#5
Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2011
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
only feel the wire getting warm on my 5000 strand or so 0 gauge wire between the battery(which is under the back seat so no firewall involved) and the fuse holder which is about 2 1/5 feet long none of the other wire is affected and its pretty much a straight forward setup and i've had plenty of extreme setups but never this problem
#6
Senior Member
True Car Nut
you could have a short anywhere on the wire to the amp and still see the heat effects at the fuse holder.
is this a new issue or has it done it since installed because i wouldnt think that would be a good location for a battery or something you know is going to make some heat under normal operation
is this a new issue or has it done it since installed because i wouldnt think that would be a good location for a battery or something you know is going to make some heat under normal operation
#9
Guest
Posts: n/a
Some fuseholders use rivet style fasteners to connect metal parts together and some are just not pressed adequately. The cure is to solder the parts together if you can get access to that joint but best yet is replace the fuseholder.
OR you may have exceeded the rating on the fuseholder. They have an (often ignored) rating for individual fuses and another rating for the whole device.
GL
OR you may have exceeded the rating on the fuseholder. They have an (often ignored) rating for individual fuses and another rating for the whole device.
GL
Thread
Thread Starter
Forum
Replies
Last Post