"My friends whe got another" problem
02-13-2008, 05:40 PM
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Nov 2006
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
"My friends whe got another" problem
I have a little problem getting out the bolt that holds the crank pulley it is very hard i i cant get it out is there any trick on getting this #%!& out
02-13-2008, 06:54 PM
#3
Member
Posts like a V-Tak
Join Date: Aug 2007
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Long extension(*) out through the wheel opening with a breaker bar(and a piece of pipe if needed). First you need to wedge a pry bar up against the torque convertor to stop the engine from turning.
02-19-2008, 10:41 AM
#5
Member
Posts like a V-Tak
Thread Starter
Join Date: Nov 2006
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
AAAAAAAA!!!!!!!!!!!!!
the bolt came out but now the pulley is giving me problems to come out wasnt it supose to come out by hand or there is some trick to get it out
has always any help will be greatly appreciated
has always any help will be greatly appreciated
02-19-2008, 01:29 PM
#6
BANNED
Join Date: Mar 2004
Location: Purgatory
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
you need a harmonic balancer puller to get it off. you should be able to rent one at the local parts store.
don't use the supplied bolts though, you need to pick up some 6mm diameter x 70mm length x 1.0 pitch (1.0 thread per mm). you will also need washers to fit the HB puller.
read more here: http://www.bonnevilleclub.com/forum/...ic.php?t=84872
don't use the supplied bolts though, you need to pick up some 6mm diameter x 70mm length x 1.0 pitch (1.0 thread per mm). you will also need washers to fit the HB puller.
read more here: http://www.bonnevilleclub.com/forum/...ic.php?t=84872
02-19-2008, 05:50 PM
#7
Member
Posts like a V-Tak
Thread Starter
Join Date: Nov 2006
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
02-20-2008, 10:36 AM
#10
Member
Posts like a V-Tak
Join Date: Aug 2007
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
You will need to put something in the hole that the crank bolt came out of so the puller has something to push against other than the pully. I use a 3/8 bolt about 2 inches long for that. As long as you know you need something in there you will see the problem.
Thread
Thread Starter
Forum
Replies
Last Post