Mix doors
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Dec 2008
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Mix doors
Now that the electrical and power steering problems have been resolved I have one last issue with my dual climate control. The dash vents on the drivers side and center will not blow cold air when the temp control is turned down. The air gets cooler but does not get cold. I had the compressor replaced last summer because of a leak and the passenger side gets cold. I can see the blend door actuators move on passenger and drivers side and all are moving when the temp is changed. The drivers side has two actuators, one that is matched with one on passenger side and a seperate one which seems to possibly control the vents. It seems to move a couple of seconds after the other. Anybody that could point me in the right direction would be greatly appreciated. Thanks.
#2
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Check to see if the lever is moving with the actuator. Also if possible listen if the door is moving. It sounds like the air mix door is not moving on that side. Not sure of the location of all the doors on your year.
Thread
Thread Starter
Forum
Replies
Last Post
geodouglas
2000-2005
10
11-13-2010 10:12 PM