Sealant question for UIM/LIM replacement?
01-17-2007, 11:39 AM
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: May 2006
Location: NC
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Sealant question for UIM/LIM replacement?
I noticed some folks are using a sealant when replacing these gaskets and some are not. What should I do and what type and where are you guys applying the sealant. Another newbie question is when looking at the UIM from the bottom with the TB side up,should the two passages directly below the stovepipe hole be open?They are open on mine but the openings look rather jagged.
(2000 SE) :?:
(2000 SE) :?:
Thread
Thread Starter
Forum
Replies
Last Post
Paul1981
2000-2005
10
12-21-2007 10:05 PM