supercharger pulley
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Jul 2007
Location: New Jersey
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
supercharger pulley
Ok so here is the situation I am in. I bought a 3.4inch pulley that I need to install. We removed the old pulley with a 3 prong puller. Tore the hell out of the old pulley. 3 prong FTW!!!!!!!!!!! I really didnt feel like spending $100 for the other puller. Now I am trying to get the new one on. Anyone know the bolt pitch that goes in the supercharger. So i can get the new one on.
#2
RIP
True Car Nut
Check with BillBoost37 over at www.nebonnevilleclub.net. He lives in CT, so not too far from you, and I believe he loans the tool out.
#3
Junior Member
Join Date: Aug 2005
Location: North of Buffalo, NY *** NEBF '05, '06, '07 *** ***ONBF & NYBF 06; 07*** ***WCBF 06***
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
For some reason I had the impression you could rent the tool from a parts store...? Maybe that is only locally...you could check around with the parts stores or local garages.
#4
Member
Posts like a V-Tak
Thread Starter
Join Date: Jul 2007
Location: New Jersey
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Ok so we finally got it on. Fortunately I had purchased another supercharger earlier in the year. And it had a screw in the end of it. So we took it out and went to home depot and Lowes and after 40 bolts nuts and washers and 12 hours later we finally got it on and it surprisingly runs great.
#6
Senior Member
Posts like a Supercharger
Join Date: Dec 2007
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 2000SilverBullet
Wait till the PCM learns in a couple days, your grin will grow.
Sweet
#7
Yes Mike, the computer will add timing and fuel as it gets used to more air over time.
I see in your sig you're going with a 3.6 pulley. Don't be a woos Go with at least a 3.5" and if you're serious about continuous improvement choose an MPS because it won't be long and you will be lusting for a 3.4.....then a 3.3......then a 3.2.....then a 3.1...................... :o
I see in your sig you're going with a 3.6 pulley. Don't be a woos Go with at least a 3.5" and if you're serious about continuous improvement choose an MPS because it won't be long and you will be lusting for a 3.4.....then a 3.3......then a 3.2.....then a 3.1...................... :o
Thread
Thread Starter
Forum
Replies
Last Post
Allmachtige
1992-1999
1
10-05-2006 08:31 PM
dbtk2
Performance, Brainstorming & Tuning
13
08-27-2003 11:30 AM
Mr Bean
1992-1999
9
02-19-2003 11:34 PM