DRL Jumper Question
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Nov 2005
Location: Columbia, MO "CoMo"
Posts: 406
Likes: 0
Received 0 Likes
on
0 Posts
DRL Jumper Question
I know the process regarding 30/87a to disable the DRL'*, but was curious as to the construction of the jumper itself. What did you use for the ends? Spade connectors? All of the spade connectors I found looked too wide. Not sure if I'm going to disable them yet but am tossing it around.
Thanks.
Thanks.
#2
I used spade connectors attached to an insulated 12ga wire but took a pair of side cutters and cut off one of the two prongs from each end. Fits like a glove into the slot and VERY secure. Also makes it a snap to remove the jumper and plug the relay back in if you need to do so.
#3
Senior Member
Certified GM nut
Originally Posted by ozarkirish87
I used spade connectors attached to an insulated 12ga wire but took a pair of side cutters and cut off one of the two prongs from each end. Fits like a glove into the slot and VERY secure. Also makes it a snap to remove the jumper and plug the relay back in if you need to do so.
#6
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Nov 2005
Location: Columbia, MO "CoMo"
Posts: 406
Likes: 0
Received 0 Likes
on
0 Posts
Got the jumper in. Works well. I'll carry the relay in the glove box during the "trial" period. I'd say I'll leave it in . Thanks for the help.
Thread
Thread Starter
Forum
Replies
Last Post