Creased fuel line
#1
Member
Posts like a V-Tak
Thread Starter
Creased fuel line
I was replacing my upper intake manifold and I bent one of the fuel lines supplying the fuel rail too far and got a "crease" in it...
Will this need to be replaced? It'* a plastic fuel line, about 0.5in OD.
If I need to replace it, do I have to replace the entire line or can I replace just the damaged portion? I have no idea... Never dealt with this before...
When I bend the line back into place, I don't see the crease. But, there is a definite give to the line when it is bent in the other direction....
Any suggestions are appreciated...
Will this need to be replaced? It'* a plastic fuel line, about 0.5in OD.
If I need to replace it, do I have to replace the entire line or can I replace just the damaged portion? I have no idea... Never dealt with this before...
When I bend the line back into place, I don't see the crease. But, there is a definite give to the line when it is bent in the other direction....
Any suggestions are appreciated...
Thread
Thread Starter
Forum
Replies
Last Post