Help with passenger side drive axle.
12-15-2007, 03:05 AM
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Jan 2003
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Help with passenger side drive axle.
I just install a rebuild transmission and rebuild drive axles. On the driver side axle the shaft push in until it was flush in the transaxle. On the passenger side axle it slide in but I still see about 1/2" of the shaft showing on the transaxle side. Is that normal? I try pulling it back out and it feels like it is lock in there. If anyone has pictures that would be great.
Thanks
Thanks
12-16-2007, 10:32 AM
#2
Senior Member
Posts like a Northstar
Join Date: Mar 2007
Location: Maumee, OH
Posts: 529
Likes: 0
Received 0 Likes
on
0 Posts
When I replaced my drivers side axle, there was a tiny bit showing. I'm assuming that this is pretty normal.
Plus the fact that you can pull it, and it'* not coming back out, I would say that you have it in properly.
Plus the fact that you can pull it, and it'* not coming back out, I would say that you have it in properly.
12-16-2007, 03:19 PM
#3
Member
Posts like a V-Tak
Thread Starter
Join Date: Jan 2003
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by slick94prix
When I replaced my drivers side axle, there was a tiny bit showing. I'm assuming that this is pretty normal.
Plus the fact that you can pull it, and it'* not coming back out, I would say that you have it in properly.
Plus the fact that you can pull it, and it'* not coming back out, I would say that you have it in properly.
Thread
Thread Starter
Forum
Replies
Last Post