Proper way of taking of?/ and passenger fender issue
#1
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Dec 2005
Location: jersey
Posts: 740
Likes: 0
Received 0 Likes
on
0 Posts
Proper way of taking of?/ and passenger fender issue
Hey guys was wondering how or what is the proper way of taking off your door panel? I'm getting a leak in my car and I need to determine were it is so I'm going to that aread first. But I don't want to break any clips or anything, I mean if I did I did I can just go and get new ones from autozone right?
Also so I didn't post 2 threads, I noticed today when I was looking at my car from the front view my passenger side front fender is popped up just a little bit on the corner of it were its by the headlight. I looked at my other one to see if it was the same but nope, the other is leveled with the hood. Now I'll post pics of it in just a second ( gotta run out and take them ) but how will I go about fixing that? Lightly tap it with a mallet?
Also so I didn't post 2 threads, I noticed today when I was looking at my car from the front view my passenger side front fender is popped up just a little bit on the corner of it were its by the headlight. I looked at my other one to see if it was the same but nope, the other is leveled with the hood. Now I'll post pics of it in just a second ( gotta run out and take them ) but how will I go about fixing that? Lightly tap it with a mallet?
#3
RIP
True Car Nut
This is a link on how to remove the door panel
http://www.bonnevilleclub.com/forum/...ic.php?t=50082
Is the fender too high, or is the hood too low? If the hood is too low, open the hood, and in the front corners you'll see some rubber/plastic supports that can be adjusted up and down to align the hood properly. Move it a little at a time, and don't over-do, or you could have problems getting the hood open.
http://www.bonnevilleclub.com/forum/...ic.php?t=50082
Is the fender too high, or is the hood too low? If the hood is too low, open the hood, and in the front corners you'll see some rubber/plastic supports that can be adjusted up and down to align the hood properly. Move it a little at a time, and don't over-do, or you could have problems getting the hood open.
Thread
Thread Starter
Forum
Replies
Last Post
ashtonr
Detailing & Appearance
13
12-27-2009 10:07 AM
ferullo0
Audio (and aftermarket electronics)
9
07-20-2007 10:43 PM
bill buttermore
Everything Electrical & Electronic
5
07-12-2004 10:31 PM