Heater Core?
#1
Member
Posts like a V-Tak
Thread Starter
Heater Core?
2001 Bonneville with 150000 on it. it'* been real cold, and while I get heat, I also smell antifreeze and have a coolant leak. When it warmed up a little, I had moisture freeze on the inside of the front window. I am guessing heatercore?
If so how do you replace? Not supercharged and no climate control.
Jim
If so how do you replace? Not supercharged and no climate control.
Jim
#4
Senior Member
True Car Nut
works for me, got this from there;
Disconnect the negative battery cable.
Drain the cooling system into a clean container for reuse.
Remove or disconnect the following:
Heater hoses from the heater core
Right sound insulator
All necessary electrical connectors and remove the instrument panel compartment
Temperature valve actuator
Electrical connector and remove the HVAC programmer
Heater core cover-to-heater assembly screws and the cover
Heater core-to-heater assembly screws and the heater core
To install:
Install or connect the following:
Heater core and the heater core-to-heater assembly screws, then, tighten the screws to 12 inch lbs. (1.4 Nm)
Heater core cover and the cover-to-heater assembly screws, then, tighten the screws to 12 inch lbs. (1.4 Nm)
HVAC programmer and connect the electrical connector
Temperature valve actuator
Instrument panel compartment and connect any necessary electrical connectors
Right sound insulator
Heater hoses to the heater core
Refill the cooling system.
Connect the negative battery cable.
Operate the engine to normal operating temperatures; then, check the climate control operation and check for leaks.
Disconnect the negative battery cable.
Drain the cooling system into a clean container for reuse.
Remove or disconnect the following:
Heater hoses from the heater core
Right sound insulator
All necessary electrical connectors and remove the instrument panel compartment
Temperature valve actuator
Electrical connector and remove the HVAC programmer
Heater core cover-to-heater assembly screws and the cover
Heater core-to-heater assembly screws and the heater core
To install:
Install or connect the following:
Heater core and the heater core-to-heater assembly screws, then, tighten the screws to 12 inch lbs. (1.4 Nm)
Heater core cover and the cover-to-heater assembly screws, then, tighten the screws to 12 inch lbs. (1.4 Nm)
HVAC programmer and connect the electrical connector
Temperature valve actuator
Instrument panel compartment and connect any necessary electrical connectors
Right sound insulator
Heater hoses to the heater core
Refill the cooling system.
Connect the negative battery cable.
Operate the engine to normal operating temperatures; then, check the climate control operation and check for leaks.
Thread
Thread Starter
Forum
Replies
Last Post