changed to tuned PCM and 3 air injection codes
#1
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Jun 2008
Location: Cleveland, OH
Posts: 1,389
Likes: 0
Received 0 Likes
on
0 Posts
changed to tuned PCM and 3 air injection codes
I changed my ZZP 1.0 PCm out with one that I tuned myself and got P0410 Secondary Air Injection (AIR)
P0412 Secondary Air Injection (AIR)
P0418 AIR Pump Relay Control Cir
At the time I scanned the DTCs only the P0410 was said to be active but the other 2 set off the light
any ideas? I'm not as happy with my tune so I might just switch back but I'm trying to see if this is related or not
P0412 Secondary Air Injection (AIR)
P0418 AIR Pump Relay Control Cir
At the time I scanned the DTCs only the P0410 was said to be active but the other 2 set off the light
any ideas? I'm not as happy with my tune so I might just switch back but I'm trying to see if this is related or not
#4
DINOSAURUS BOOSTUS
Expert Gearhead
The case learn is a good recommendation. It won't help the codes though.
Most likely you started with a bin file from a car that had a seconardy pump enabled. My suggestion is to confirm you don't have the pump (located under top radiator hose between engine and body. Then set those codes to non-reporting.
Most likely you started with a bin file from a car that had a seconardy pump enabled. My suggestion is to confirm you don't have the pump (located under top radiator hose between engine and body. Then set those codes to non-reporting.
Thread
Thread Starter
Forum
Replies
Last Post
agrazela
Performance, Brainstorming & Tuning
5
06-19-2007 10:24 PM
rwe62382
Performance, Brainstorming & Tuning
1
08-30-2003 01:03 AM