02 bonneville TPS
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Feb 2007
Location: Columbus, Ohio
Posts: 254
Likes: 0
Received 0 Likes
on
0 Posts
02 bonneville TPS
So i pulled the three sensors off the throttle body prior to pulling it off to clean inside of it. 3 meaning the TPS, IAC, and the MAF. Cleaned everything and put them all back on and now im getting an SES light. Took it to the nearest advaned auto parts store and it read that its the TPS sensor. It said circuit A low input or something. So its deffinately the TPS. The car when i first started it up after putting all the sensors back on idled kind of high at 2k rpms. I looked to make sure all of them were on right and i just messed with the throttle cable behind the throttle body and it idled like normal. So i turned it off. Turned it back on and the ses light came on but everything still seems fine. I tried to erase the code from the OBD2 scanner and it said it cleared but the ses light still remained on. The car drives fine the throttle seems fine. How do i get it to go off (the ses light).
#2
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
When you put the TPS back on, did you just put it on and bolt it up? Or did you put it on and then turn it a bit to line up the holes? Take a look at this. https://www.gmforum.com/normal-maintainence-138/throttle-position-sensor-tps-replacement-284336/ It'* possible you don't have it lined up right.
Thread
Thread Starter
Forum
Replies
Last Post