Engine cradle bolts broke
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2011
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Engine cradle bolts broke
Ok ive been back and forth with this car and finally think i have everything fixed and as im tightening the cradle bolts and two of them snap off in half and now the cradle is hanging what options do i have to get this back right
#3
Senior Member
True Car Nut
Was the cradle fully seated, or were you using the bolts to drive it home? What size cheater bar were you using to drive the bolts? Did you buy proper bolts, or Home Depot bolts of the same size? Were you re-using old bolts?
I would try to figure out how you broke bolts before just putting new ones in.
I would try to figure out how you broke bolts before just putting new ones in.
#4
Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2011
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
I used the original bolts and the bar was about 4 feet long and the cradle was seated the bolts only had maybe about a halt turn until fully in and they snapped. but how am i goin to get the remaining pieces out of the frame? its the two rear points on the driver side. would grade 8 bolts work better? i just hope i didnt brick my car over broken bolts
#5
Senior Member
Posts like a Corvette
Join Date: Feb 2007
Location: Sanford Michigan
Posts: 1,201
Likes: 0
Received 0 Likes
on
0 Posts
A 4 foot cheater bar is WAY overkill for tightening these bolts. I don't remember the exact specs, so you will have to look it up, but they are only supposed to be torqued to around 65 ft. lbs.
#6
Senior Member
True Car Nut
Okay, so now we know why the bolts broke. The only thing I can suggest is drilling a hole in the center of each broken bolt and using a bolt extractor (search ebay for that term).
Thread
Thread Starter
Forum
Replies
Last Post