crankshaft sensor
03-20-2007, 03:55 AM
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Nov 2006
Location: hamilton,ohio
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
crankshaft sensor
1997 bonneville
my check engine light . crankshaft sensor no signal. i put a new in but still no signal.
my car will not start half of the and if you turn it off it will not start back.idle bad and dies
but if you get past the die and bad idle it runs good but if its warm it will not start it has to cool off
new parts:
Crankshaft posit sensor
throttle posit sensor
mass air flow sensor
ignition module
coolant temp sensor
wires and plugs
my check engine light . crankshaft sensor no signal. i put a new in but still no signal.
my car will not start half of the and if you turn it off it will not start back.idle bad and dies
but if you get past the die and bad idle it runs good but if its warm it will not start it has to cool off
new parts:
Crankshaft posit sensor
throttle posit sensor
mass air flow sensor
ignition module
coolant temp sensor
wires and plugs
03-20-2007, 06:55 AM
#2
DINOSAURUS BOOSTUS
Expert Gearhead
bls.. your post is a little cryptic to understand.
What codes are illuminating the check engine light?
You mention the car starts some of the time. If the codes are cam sensor related, that would make more sense with the symptoms, however...let'* help you diagnose it before sending you to buy more parts that may not be bad.
Please pull and report back on the actual codes and their names. We'll go forward from there.
What codes are illuminating the check engine light?
You mention the car starts some of the time. If the codes are cam sensor related, that would make more sense with the symptoms, however...let'* help you diagnose it before sending you to buy more parts that may not be bad.
Please pull and report back on the actual codes and their names. We'll go forward from there.
03-21-2007, 08:29 AM
#3
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Nov 2006
Location: hamilton,ohio
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Camshaft Position (CMP) Sensor Performance
po-341 cmp sensor
i also need a new fuel pump ($615. at kirsch'* automotive)
i also need a new fuel pump ($615. at kirsch'* automotive)
03-21-2007, 09:06 AM
#4
DINOSAURUS BOOSTUS
Expert Gearhead
From Techinfo at the top of the page.
DTC P0341 Camshaft Position (CMP) Sensor Performance
Please change the title of your post to be more appropriate. This is a cam sensor code... Was any work done in the past few months? Waterpump etc?
First thing to do is (car off) reach in around the belts to the left of the waterpump and find the connector. Ensure it is seated properly. Look over the wiring for any rubs or nicks to the best of your ability.
The sensor is under $50 (I don't remember exactly) and the cam sensor being bad or unplugged will cause the car to have a 1 in 6 chance of starting each time you turn the key.
The fuel pump is ~$120 as a part. That $600 number is nuts unless they are installing it and gold plating while in there.
DTC P0341 Camshaft Position (CMP) Sensor Performance
Please change the title of your post to be more appropriate. This is a cam sensor code... Was any work done in the past few months? Waterpump etc?
First thing to do is (car off) reach in around the belts to the left of the waterpump and find the connector. Ensure it is seated properly. Look over the wiring for any rubs or nicks to the best of your ability.
The sensor is under $50 (I don't remember exactly) and the cam sensor being bad or unplugged will cause the car to have a 1 in 6 chance of starting each time you turn the key.
The fuel pump is ~$120 as a part. That $600 number is nuts unless they are installing it and gold plating while in there.
Thread
Thread Starter
Forum
Replies
Last Post