LIM/UIM replaced still same issue!!!!
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Apr 2007
Location: Bellevue,Ohio
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
LIM/UIM replaced still same issue!!!!
Hey guys, I just finished replacing my upper intake manifold that I got from parts network and aluminum lower intake manifold gaskets from GM, changed the oil, and when I went to start it white smoke started to come from the exhaust AGAIN!!!! What is the deal? Any ideas? I was about to ram my fist through the wall, but that would only cause more problems....
#3
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Apr 2007
Location: Bellevue,Ohio
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the reply, the original thread was under "Crank Sensor" but Bill Boost suggested I change it. I dont know how long it would have ran, I shut it off cause I did not want it to hydrolock again. Do you think it just blowing old stuff out?
#4
RIP
True Car Nut
You'll often end up with coolant in the cylinders when you pull off the LIM gaskets. It could take a good 30 minutes or so for it to burn it all off. Change the oil again in about a week to 10 days.
#5
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Apr 2007
Location: Bellevue,Ohio
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Your right, I was flipping out because I thought the LIM did not seal right and it was starting all over again...I let it run for a bit while longer and it did clear up, thank goodness! Now I have a small issue with the gauges, they dont work. I am sure I connected everything. They light up but dont respond to anything,: RPM, Oil pressure, fuel, nothing is registering any thoughts on this little diddy?
Thread
Thread Starter
Forum
Replies
Last Post
Paul1981
2000-2005
10
12-21-2007 10:05 PM