Steering "falls" while turning
#1
Member
Posts like a V-Tak
Thread Starter
Steering "falls" while turning
Hello,
While on onramps, offramps, or just tighter turns in general, I can steer to a point under acceleration then it "falls" or gives or oversteers where I have to couter to keep it from putting me in the wall!! I have had it up and the tie rods look good, hub bearing is fine, and I replaced the struts and mounts, plus an alignment. This problem is bad, and getting worse, after reading here about the possibility of strut mounts I figured I was due for some struts anyway.... that didn't help at all.
Any ideas?
While on onramps, offramps, or just tighter turns in general, I can steer to a point under acceleration then it "falls" or gives or oversteers where I have to couter to keep it from putting me in the wall!! I have had it up and the tie rods look good, hub bearing is fine, and I replaced the struts and mounts, plus an alignment. This problem is bad, and getting worse, after reading here about the possibility of strut mounts I figured I was due for some struts anyway.... that didn't help at all.
Any ideas?
Thread
Thread Starter
Forum
Replies
Last Post
malibuolds
Everything Electrical & Electronic
22
06-02-2005 03:25 AM