need help
#1
Senior Member
Posts like a 4 Banger
Thread Starter
Join Date: Jul 2007
Location: burlington,mass
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
need help
i have been tryin to do my water pump since yesterday and im stuck on one bolt for the motor mount is there a trick to get it off...its the bolt on the left under on the body if your standing above it i have all other bolts out and the engine supported but i cant get this one bolt out...so any tricks hints or any thing would be really help full
#4
Senior Member
Posts like a 4 Banger
Thread Starter
Join Date: Jul 2007
Location: burlington,mass
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
i have access but i just cant get it out its like it was put in buy a gorilla with an impact gun.. i just wasnt sure if there was any trick. i cant even break it loose
#7
Senior Member
True Car Nut
Ahhh, so it IS the same as on mine.
Then yes, do as John says and use some PB Blaster on it. Let it set for 10-20 minutes while you take a break, then give it a go.
Then yes, do as John says and use some PB Blaster on it. Let it set for 10-20 minutes while you take a break, then give it a go.
#10
Junior Member
Posts like a V-Tak
Join Date: Aug 2007
Location: Saginaw, MI
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
IF the problem is access then find a lower profile breaker and socket. Also you can jack up the engine a couple inches without taking off the engine mounts. Just make sure to give plenty of support to your tranny pan or you will poke a hole in it jackin off it. (not jacking the tranny off )
x2 on the pipe. FIne a 4' long piece of pipe and put it over the wrench if you need to. If double ended fine a cheap one and cut off one end.
x2 on the pipe. FIne a 4' long piece of pipe and put it over the wrench if you need to. If double ended fine a cheap one and cut off one end.