OBD Question
#1
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2007
Location: Atlanta
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
OBD Question
I am trying to retreve codes from my CCR by following the procedure that is listed here. The only problem is that when I went to put a jumper between pin 3 and 4, the spot for 4 is blank. As a matter of fact most of the spots on the top are blank. Am I looking at it up side down? Any ideas?
#3
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2007
Location: Atlanta
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Well that is what I thought I was looking at, and sure enough the #4 pin is an empty spot. I am going down to the car now to look at it a second time. Maybe I am just not looking at it right. It is the plug up under the dash on the drivers side right?
#5
Senior Member
True Car Nut
Join Date: Jan 2005
Location: Montevideo, MN MWBF '05, '06, '07 WCBF '06 '07 survivor
Posts: 3,882
Likes: 0
Received 0 Likes
on
0 Posts
#6
Junior Member
Posts like a Ricer Type-R
KMC, this is the 3rd topic you've asked this in. Please pick one and stick to it. Please also edit your profile and put your year and trim level in your signature so we know what you have.
Thread
Thread Starter
Forum
Replies
Last Post
Drifter420
Everything Electrical & Electronic
6
12-30-2017 10:25 PM
dumbsioux
Everything Electrical & Electronic
7
11-29-2004 11:39 AM