Need my power back!!
#1
Junior Member
Thread Starter
Join Date: Jul 2011
Location: Cuba City, Wisconsin
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Need my power back!!
I have had trouble with a P0336B code. I have replaced the crank sensor and installed a known good ignition module but vehicle is still REAL sluggish 75% of the time. When hooking the scan tool to it I still have no data on the 18x crank signal. Any ideas where to go from here? Vehicle will take of good and then just fall on its face. Replaced fuel filter and performed a injector service to no avail.
#3
Senior Member
True Car Nut
LIke Dan said, it would be much better if you tell what year and model of car you are referring to.
You may need a case learn for the installation of the crank shaft position sensor.
You may need a case learn for the installation of the crank shaft position sensor.
#5
Junior Member
Thread Starter
Join Date: Jul 2011
Location: Cuba City, Wisconsin
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Yea I suppose that would help a little wouldn't it. Sorry guys, it'* a '97 Bonneville SE. I had replaced the plus and wires about a month ago. One of the coil towers was rusty and caused a miss, I cleaned the coil up and put the best Carquest plug wires and rapidfire plugs in it. The car ran great again after that, I've been messing with this latest problem for about a week now.
Thread
Thread Starter
Forum
Replies
Last Post
options13
Everything Electrical & Electronic
11
08-13-2006 01:42 PM
kalinodark
Everything Electrical & Electronic
8
09-20-2004 09:10 PM