What is the size of the screws for the TPS?
03-10-2007, 12:57 AM
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Mar 2006
Location: NY
Posts: 400
Likes: 0
Received 0 Likes
on
0 Posts
What is the size of the screws for the TPS?
Hi I want to replace my TPS screws with allen head screws and was wondering what the dimentions are. I looked up an earlier post that said that the dimentions were M4x12mm. Is that correct? Thanks in advance!
03-10-2007, 10:30 AM
#3
Junior Member
Posts like a Ricer Type-R
They are M4. I don't recall the length off the top of my head. jr's3800 may. I sent him a full replacement set of hex-head cap screws for his ZM throttle body. Or you can measure the thickness of the TPS in mm'*, then add another good bit for your length. The holes for the TPS are rather deep.
Hex-head will make it much easier to remove without removal of the TB. That'* a good move. I do that to all the TB'* that come through here. Star washers are also a good idea, as is BLUE loctite on the threads.
Hex-head will make it much easier to remove without removal of the TB. That'* a good move. I do that to all the TB'* that come through here. Star washers are also a good idea, as is BLUE loctite on the threads.
Thread
Thread Starter
Forum
Replies
Last Post