How to remove back seats?
#1
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Jun 2004
Location: Central NJ
Posts: 1,544
Likes: 0
Received 0 Likes
on
0 Posts
How to remove back seats?
i wanan know how to remove the back seats cuz right now i got alot of visible wiring and i wanna find a place underneath to hide it all
#2
Senior Member
Posts like a Northstar
Join Date: Jan 2005
Location: Richfield, MN
Posts: 781
Likes: 0
Received 0 Likes
on
0 Posts
Stick your hand down between the rear of the bottom cushion and the bottom of the upper cushion, then lift up. Once u get that done push forward on the front of the lower cushion one side at a time and lift out.
#5
Senior Member
True Car Nut
Join Date: Jun 2004
Location: Rochester, NY (college)
Posts: 6,182
Likes: 0
Received 0 Likes
on
0 Posts
I did not take the seats out to run my amp wires, I jsut shoved my hand through where the back support and but support meet at the passenger side of the car. Pleanty of room for 2 arms in there.
Although I would like to know how to get the seat out because this spring I will be insulating it all.
Although I would like to know how to get the seat out because this spring I will be insulating it all.
#8
Senior Member
True Car Nut
There is a retainer slot for the bench on each side of the car about a foot inboard of the door. I have always removed the bench part of the seat by squatting in the rear footwell, facing the rear of the car. Then push the frame of the seat bench toward the back of the car with my knee, as I lift up on the bench. Once you have popped the bench out you will see the nuts that hold the seat back in place. But you should have enough room to run the wires without removing the seat back..
#9
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Jun 2004
Location: Central NJ
Posts: 1,544
Likes: 0
Received 0 Likes
on
0 Posts
well the wires on the interior are all concealed, its the stuff in the truck which is why i need to remove the seat back, i know you dont actually see it mos tof the time but when i do it annoys me, btw would it be possible to put the cap down there? i didnt tihnk caps needed ventilation