How to replace a cup holder?
#1
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Nov 2002
Location: Oshawa
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
How to replace a cup holder?
I bought a complete cup holder assembly (for the center console), and i'm trying to replace it, but i don't know how to get to that one bolt from underneath power seat buttons.(without breaking it!)
Thanks for any help.
Thanks for any help.
#2
Senior Member
Posts like a Turbo
Join Date: May 2002
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
The power seat control pod should pop right out. Take a flat-head screwdriver and place it to either side of the power seat pod, down in-between the pod and the actual console. Carefully, but most likely with some force, pry up. repeat this for the otehr sdie it it should pop right out. All it does is snap down into the console. It is not held in by and screws or bolts so dont worry about breaking it.
Just some advice.
Just some advice.
#3
Senior Member
Posts like a 4 Banger
Join Date: Dec 2002
Location: New Jersey, USA
Posts: 147
Likes: 0
Received 0 Likes
on
0 Posts
I'd like to know where I can get a replacement cup holder (or at least the part number so I can get it from gmpartsdirect). Also, my seats have the controls on the front of the seats themselves, so where the SSE/i'* and SLE'* have their 9 power seat buttons, I just have a blank plastic face. Does anybody know if I can just pry this up as well? Thanks a lot!
Thread
Thread Starter
Forum
Replies
Last Post
ssesc93
General GM Chat
6
01-27-2005 11:15 PM
baggsend
1992-1999
4
12-24-2003 11:22 AM