1992-1999 Series I L27 (1992-1994 SE,SLE, SSE) & Series II L36 (1995-1999 SE, SSE, SLE) and common problems for the Series I and II L67 (all supercharged models 92-99) Including Olds 88's, Olds LSS's and Buick Lesabres Please use General Chat for non-mechanical issues, and Performance and Brainstorming for improvements.

Fuel rail not holding pressure?

Thread Tools
 
Search this Thread
 
Old 08-10-2004, 02:49 PM
  #1  
Senior Member
Certified GM nut
Thread Starter
 
SSEBONNE4EVA's Avatar
 
Join Date: Feb 2004
Location: CT
Posts: 2,099
Likes: 0
Received 1 Like on 1 Post
SSEBONNE4EVA is on a distinguished road
Default Fuel rail not holding pressure?

While doing my Intake & gaskets I went to relieve the fuel pressure at the rail and
nothing?
Could it be the check valve in the fuel filter? If there is one?
Its been on since I bought the car two years ago as I was told it was just changed.
I soaked the injectors in 50/50 gas and fuel injection cleaner while doing the intake.
Does seem to have a little longer crank time at first start in morning.
Old 08-10-2004, 02:59 PM
  #2  
Junior Member
 
SSEi95's Avatar
 
Join Date: May 2002
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
SSEi95 is on a distinguished road
Default

I know when I did my SC a while back, I didn't get much preassure out of the reail when I disconnected it. I think if the car isn't on, the fuel pupmp won't prime the lines up to preassure. Maybe someone else can verify this at all?
Old 08-10-2004, 03:44 PM
  #3  
Senior Member
Certified GM nut
 
DrJay's Avatar
 
Join Date: Feb 2003
Location: Georgia
Posts: 2,095
Likes: 0
Received 0 Likes on 0 Posts
DrJay is on a distinguished road
Default

Its normal to have it lose pressure given enough time. If its just leaking back into the fuel tank its not much of an issue but if its leaking from your injectors that could be a nasty problem. You can hook a fuel pressure gauge to the schrader (sp?) valve and check from there or if you don't have one the free version is as follows:

Raise the fuel rail a few inches above the manifold, injectors included, and turn the key on...*tada!*

Its a good idea to place a paper towel under the injectors. This helps keep anything from falling into the engine and also makes it easier to determine which injector may be leaking.
Old 08-10-2004, 06:26 PM
  #4  
Senior Member
Certified GM nut
Thread Starter
 
SSEBONNE4EVA's Avatar
 
Join Date: Feb 2004
Location: CT
Posts: 2,099
Likes: 0
Received 1 Like on 1 Post
SSEBONNE4EVA is on a distinguished road
Default rail

Never though of that. Could have done it when I installed the fuel rail today.
OH well.
Its definitly not holding pressure at all. If I get in the car and key it up then turn off
and check pressure there is none.
I don't think its leaking at the injectors, I just soaked them and the car starts right up no problem. If it were flooding fuel in the cylinders it would take a while to start and skip a little at first. I think.
Old 08-10-2004, 07:20 PM
  #5  
Senior Member
Certified Car Nut
 
J Wikoff's Avatar
 
Join Date: Mar 2003
Posts: 12,433
Likes: 0
Received 2 Likes on 2 Posts
J Wikoff is on a distinguished road
Default

Bad fuel pressure regulator? Sounds likely to me.
Old 08-11-2004, 08:24 AM
  #6  
Senior Member
Certified GM nut
Thread Starter
 
SSEBONNE4EVA's Avatar
 
Join Date: Feb 2004
Location: CT
Posts: 2,099
Likes: 0
Received 1 Like on 1 Post
SSEBONNE4EVA is on a distinguished road
Default regulator

could I remove it from the rail and clean it out?
I heard they are expensive.
Maybe I'll try the 10 dollar filter first then the reg.
Old 08-11-2004, 06:53 PM
  #7  
Senior Member
Certified Car Nut
 
J Wikoff's Avatar
 
Join Date: Mar 2003
Posts: 12,433
Likes: 0
Received 2 Likes on 2 Posts
J Wikoff is on a distinguished road
Default

There is a snap ring holding it in. You could try flushing it out, but normally the internal diaphram, or whatever is in there, has worn out with age. They're about $50 from GMPD.
Old 08-12-2004, 10:08 AM
  #8  
Senior Member
Certified GM nut
Thread Starter
 
SSEBONNE4EVA's Avatar
 
Join Date: Feb 2004
Location: CT
Posts: 2,099
Likes: 0
Received 1 Like on 1 Post
SSEBONNE4EVA is on a distinguished road
Default regulator

Thanks for the info.
What should I flush it out with? Don't wan't to ruin the diaph. worse with something like carb cleaner.
Maybe I should add fuel injector cleaner to the tank at next fill up and see if that cleans it out?
Old 08-12-2004, 10:28 AM
  #9  
Senior Member
True Car Nut
 
Kennginn's Avatar
 
Join Date: Jan 2004
Location: Chicago,IL MWBF '04 SURVIVOR MWBF '05 SURVIVOR Napa Manager
Posts: 3,955
Likes: 0
Received 0 Likes on 0 Posts
Kennginn is on a distinguished road
Default

Originally Posted by SSEi95
I know when I did my SC a while back, I didn't get much preassure out of the reail when I disconnected it. I think if the car isn't on, the fuel pupmp won't prime the lines up to preassure. Maybe someone else can verify this at all?
that happends with me also
Old 08-13-2004, 09:23 AM
  #10  
Senior Member
Certified GM nut
Thread Starter
 
SSEBONNE4EVA's Avatar
 
Join Date: Feb 2004
Location: CT
Posts: 2,099
Likes: 0
Received 1 Like on 1 Post
SSEBONNE4EVA is on a distinguished road
Default pressure

So we have more than a few cars out there that are not holding pressure.
I think there is also a check valve in the fuel pump according to my book.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
joshua
Pontiac
3
03-17-2015 11:53 PM
Nighthwk12
Mechanical
0
02-19-2011 07:10 PM
charliemax
1992-1999
3
10-10-2009 07:07 PM
94bonnie
1992-1999
3
01-02-2007 07:22 PM



Quick Reply: Fuel rail not holding pressure?



All times are GMT -4. The time now is 03:22 PM.