torque specs and tightening squence of the LIM and UIM?
#1
Senior Member
Posts like a 4 Banger
Thread Starter
Join Date: Feb 2007
Location: Baltimore City, Maryland
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
torque specs and tightening squence of the LIM and UIM?
can anybody send me the torque specs and tightening squence of the LIM and UIM gaskets..pictures if posible..i found this one page on here that had the UIM gasket with numbers next to telling the squence anybody seen this. if so send the link. thanks!
#2
Senior Member
True Car Nut
Join Date: Feb 2006
Location: Melrose
Posts: 4,596
Likes: 0
Received 0 Likes
on
0 Posts
Sure!! All of the Torque Specs ae listed in Techinfo.
http://www.bonnevilleclub.com/forum/...e=article&k=18
Tightening sequence should be done carefully. Snug them up in a criss cross pattern then torque em up in the same pattern
http://www.bonnevilleclub.com/forum/...e=article&k=18
Tightening sequence should be done carefully. Snug them up in a criss cross pattern then torque em up in the same pattern
#4
Senior Member
Posts like a 4 Banger
Thread Starter
Join Date: Feb 2007
Location: Baltimore City, Maryland
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
right on time thanks....now what do i need to add to a torque wrench....will i need like a 10in extension or what. and about how much is one good enough for the job?
#6
Junior Member
Posts like a Ricer Type-R
The extension is dictated by what you need on it to reach. It will not affect torque value.
Don't use a universal joint.
Buy a torque wrench that will put you in the range you need for the full top-end. If it'* ft/lbs, do the math, if it'* inch/lbs, do the math.
Either ft or in/lbs will do as long as all the values fall within the range of the wrench you buy.
Don't use a universal joint.
Buy a torque wrench that will put you in the range you need for the full top-end. If it'* ft/lbs, do the math, if it'* inch/lbs, do the math.
Either ft or in/lbs will do as long as all the values fall within the range of the wrench you buy.
#8
Senior Member
Posts like a Camaro
Join Date: Dec 2005
Location: Clovis, CA
Posts: 851
Likes: 0
Received 0 Likes
on
0 Posts
Alright in that case, all you need for the job is an inch pound torque wrench. A 20-200 inch pound torque wrench will do. Don't forget to zero it out when you're done.
11 ft.lbs = 132 in.lbs
89 in.lbs = 89 in.lbs
11 ft.lbs = 132 in.lbs
89 in.lbs = 89 in.lbs
Thread
Thread Starter
Forum
Replies
Last Post
Paul1981
2000-2005
10
12-21-2007 10:05 PM