EGR and stuff
#1
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Apr 2010
Posts: 518
Likes: 0
Received 0 Likes
on
0 Posts
EGR and stuff
I hooked up my car to a Solus pro engine scanner and read the information at idle. my idle is rough and sounds like a vacuum leak but cannot find any. I'm curious where the common egr leak is at for the SII?
#6
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Apr 2010
Posts: 518
Likes: 0
Received 0 Likes
on
0 Posts
No its the pipe that goes to the manifold but it is cracked where the tube meets the egr bracket. is there any temporary fix i can make until i can afford a new pipe?
#7
Member
Posts like a V-Tak
Lower intake to EGR Bracket. Pipe part # 24508516. Dealer retail $24.58.
I just had to replace mine last week. Easy job. Just remove the throttle body after you drain out some coolant.
I just had to replace mine last week. Easy job. Just remove the throttle body after you drain out some coolant.
#9
Member
Posts like a V-Tak
Goodluck putting the new one on without removing the throttle body. I found the new one to be a bit larger in diameter. The ends were the same size. If you remove the throttle body it'* a good idea to replace that seal as well.
#10
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Apr 2010
Posts: 518
Likes: 0
Received 0 Likes
on
0 Posts
I think as a temporary fix until i can afford one (as I have a crappy job and bills to pay) I will put the silicone gasket seal stuff around the crack and where the lips meet the manifolds.
Thread
Thread Starter
Forum
Replies
Last Post