Lower Idle after Wire and Plug Tune Up
#1
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2007
Location: ThatCity ID
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Lower Idle after Wire and Plug Tune Up
I just installed Autolite 605'* and MSD 8.5MM wires, everything seems to run fine while under acceleration but when im at a stop sign or red light, my RPM'* seem to fluctuate between 1000 and 500 and bucks a little, i did have a misfire code on cyclinder 6 but i fixed this problem and i do not have any codes anymore.. any idea what this could be, i am still using my stock coils ...
#4
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2007
Location: ThatCity ID
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
fixed flucuation idle
Cyclinder 6 spark plug gap was almost complety closed but wasnt setting a code , fixed the gap and everything seems fine
#7
DINOSAURUS BOOSTUS
Expert Gearhead
If you hadn't found #6 to be uh.. "improperly gapped" I would have suggested turning off the AC. Many mistake the AC cycling and adding engine load as a problem .
Thread
Thread Starter
Forum
Replies
Last Post