O2 sensor connector question
#1
Senior Member
Posts like a Supercharger
Thread Starter
Join Date: Jan 2008
Location: Orlando Florida
Posts: 182
Likes: 0
Received 0 Likes
on
0 Posts
O2 sensor connector question
I have noticed a decrease in fuel economy after I had to change to a new MAF sensor after I did the UIM/LIM job.
I went ahead and did a Plug and wire job first, but the gas mileage still kinda stinks so i want to go ahead and replace the front O2 sensor...it is well over due anyhow..
so my question is which connector do i use? One is square and one is flat. Trying to order this part while at work and thought i could get a quick answer here before i get off work and pop the hood to see which connector i need..here are what the two look like
Both of these parts are listed as "for my car"...I know not to get bosch, but anyone heard good or bad things about "tru-tech", denso, or AC delco?
I went ahead and did a Plug and wire job first, but the gas mileage still kinda stinks so i want to go ahead and replace the front O2 sensor...it is well over due anyhow..
so my question is which connector do i use? One is square and one is flat. Trying to order this part while at work and thought i could get a quick answer here before i get off work and pop the hood to see which connector i need..here are what the two look like
Both of these parts are listed as "for my car"...I know not to get bosch, but anyone heard good or bad things about "tru-tech", denso, or AC delco?
#2
Guest
Posts: n/a
Being that you are a 1996 you will want the pig tail above... or the Equivalent to the AC Delco AFS-75
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Thread
Thread Starter
Forum
Replies
Last Post