copied from manual ... it is pin 4 to 8

PROGRAMMING PROCEDURE
TRANSMITTER & RAC PROGRAMMING
NOTE: Following procedure must be performed when replacing RAC
module or either transmitter.
1) Turn ignition switch to OFF position. Use a fused jumper
wire and connect Data Link Connector (DLC) terminals 4 (Black wire)
and 8 (Black/White wire). See Fig. 1. Door locks, fuel door and trunk
lid release should activate in approximately 2 seconds.
2) Press any button on one transmitter. Door locks, fuel door
and trunk lid release should activate in approximately 2 seconds.
First transmitter is now programmed. Repeat this step using other
transmitter. If only one transmitter is being used, disconnect jumper
wire from DLC. If module does not accept programming, see
RAC MODULE CANNOT BE PROGRAMMED under TROUBLE SHOOTING.

oops... wrong login ... but you know the point..

Does anyone have the instructions for programming the keyless. I just bought the car. I was given 4 fobs only one works replaced the batteries in the others but they don't work. I just think I need to program them. Thanks Joe P.

Joe, this topic is nearly 3 years old. Please don't dig up the old ones.

Start a new topic, or look in TECHINFO at the top of the page.