Cupholder questions and answers:
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Cupholder questions and answers:
I have a 2nd design cupholder for my 93 SSEi, and recently bought a used cupholder from Billboost for the 95 (it was missing when purchased).
Noticed some differences:
Note the difference in width of the tabs. 2nd Gen 93 on the left, the one from billboost on the right. This will not fit into the holes in the bezel on either the 93 or 95 without modification
2nd Gen top, unknown bottom
2nd Gen right, unkown left
Is this unkown cupholder from a 96-99?
Noticed some differences:
Note the difference in width of the tabs. 2nd Gen 93 on the left, the one from billboost on the right. This will not fit into the holes in the bezel on either the 93 or 95 without modification
2nd Gen top, unknown bottom
2nd Gen right, unkown left
Is this unkown cupholder from a 96-99?
#5
Junior Member
Posts like a Ricer Type-R
Thread Starter
Hmmm....not sure I'm going to be able to make this work. That broken tab on the new one is in the wrong spot. Both tabs are too wide towards the inside edges if you know what I mean. I need to trim those inside edges, but one of the outside tabs is missing.
Thread
Thread Starter
Forum
Replies
Last Post
lash92ssei
General GM Chat
5
02-27-2004 08:38 PM