90 sse master cylinder
#11
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Jul 2002
Location: Oak Ridge, TN
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Master Cyl
I believe you would more that likely have to bleed them. It is very easy to do.
I finally fiexed my problem with the gold platted master cylinder.
I found one off a 90 Cadilac. I installed the entire unit. When I did the brake peddle was only inches from the floor. Therefore, I had to manufacture a brake rod extension to bring the peddle to the right height. What a pain in the but!!!! I hope this master cylinder will hold out.
I finally fiexed my problem with the gold platted master cylinder.
I found one off a 90 Cadilac. I installed the entire unit. When I did the brake peddle was only inches from the floor. Therefore, I had to manufacture a brake rod extension to bring the peddle to the right height. What a pain in the but!!!! I hope this master cylinder will hold out.
#12
Senior Member
Posts like a Turbo
Join Date: Jul 2002
Posts: 417
Likes: 0
Received 0 Likes
on
0 Posts
Re: Master Cyl
Originally Posted by string
I believe you would more that likely have to bleed them. It is very easy to do.
I can bleed one wheel in just a few mintues but Bleeding the whole system will take a good bit longer by myself. It would take much much longer if I have to bleed the master cylinder.
Thread
Thread Starter
Forum
Replies
Last Post
88bonnsse
1987-1991
7
05-03-2007 02:56 AM