Fog light install, best place to penetrate firewall?
#1
Senior Member
Certified GM nut
Thread Starter
Join Date: Jan 2004
Posts: 1,656
Likes: 0
Received 0 Likes
on
0 Posts
Fog light install, best place to penetrate firewall?
I really hate the idea of puncturing a grommet or drilling holes. Is there another place I can run wires for the switch? I know someone has been down this road before
Thanks in advance!
Thanks in advance!
#3
Senior Member
Certified GM nut
Thread Starter
Join Date: Jan 2004
Posts: 1,656
Likes: 0
Received 0 Likes
on
0 Posts
Ended up trying to gently push them thru the grommet that the shift cable runs thru. Grommet spilled out its hole, however the wires went thru the grommet and nothing is touching or near metal. My brother helped, we ty wrapped everything and ran the black split tubing all over the wires. Used a relay kit and bolted it near the battery, hooked up the main power at the buss on the firewall. Remote switch was put for now on the door panel till I can think something better and wired the switch power with a key on wire so the ignition switch has to be ON before the lights are on.
These things are freeking BRIGHT too! If I owned a camera, I would post pics but take my word!
The old girl is getting CLOSE to 200k miles, just keeps going and going.
These things are freeking BRIGHT too! If I owned a camera, I would post pics but take my word!
The old girl is getting CLOSE to 200k miles, just keeps going and going.
Thread
Thread Starter
Forum
Replies
Last Post
Dachipsta
Audio (and aftermarket electronics)
1
03-28-2009 11:05 PM