I know it's been asked before...
#1
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Jan 2005
Location: Richfield, MN
Posts: 781
Likes: 0
Received 0 Likes
on
0 Posts
I know it'* been asked before...
Just to make absolutely sure, is this the muffler i need to fit? I finally decided on the flowmaster for mine. It'* an '87 with the single in, dual out (on one side) muffler. Is this the one i need to order?
#2
Senior Member
Posts like a Corvette
Join Date: Jul 2004
Location: Winnipeg, Manitoba, Canada
Posts: 1,445
Likes: 0
Received 0 Likes
on
0 Posts
Flowmaster 80 Series, it is designed for Camaro/Firebird applications but works for us as well. Your setup is going to be different after you get the flowmaster. It has an in/out on one side and an out on the other. So those dual pipes on the one side will be seperated and there will be one on each side. So you will need two new pipes fabricated for the outlets.
Heres a diagram to explain why:
All said and done:
Heres a diagram to explain why:
All said and done:
#3
Senior Member
True Car Nut
Join Date: Apr 2004
Location: Three Oaks, Michigan
Posts: 4,879
Likes: 0
Received 0 Likes
on
0 Posts
Damn captain, that'* a nice diagram!
Just for a note, where "N.A." is, that'* the rear header.. not that tube.
Also, there are some single output flowmasters.. but it would be the same setup, minus one output. I believe the output on those looks something like this [this is a shitty diagram].
-----in--------==========================
| |
| |
| |
| | -------------out-------------
==========================
-justin
Just for a note, where "N.A." is, that'* the rear header.. not that tube.
Also, there are some single output flowmasters.. but it would be the same setup, minus one output. I believe the output on those looks something like this [this is a shitty diagram].
-----in--------==========================
| |
| |
| |
| | -------------out-------------
==========================
-justin
#4
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Jan 2005
Location: Richfield, MN
Posts: 781
Likes: 0
Received 0 Likes
on
0 Posts
Ya thanks guys, i knew that the pipes needed to be re-done i just wanted to make sure that was the correct inlet size. Thanks again!
Thread
Thread Starter
Forum
Replies
Last Post
wild-one
Performance, Brainstorming & Tuning
11
09-15-2004 10:58 AM